Weirdness between Repetier Host and Mattercontrol

[dredge999]

I am using the latest Mattercontrol and the latest Repetier host.

I have Mattercontrol up and printing and wanted to mess around with Repetier Host.

The settings for printer shape have changed a bit in the latest releases. I have Selected Rostock Printer in the Printer Type pulldown.
Then home X: 0
Home Y: 0
Home Z: Max

Printable radius 135mm
Printable height: 350mm

The printer runs fine in Mattercontrol and I have set up everything to be the same as far as presets go when compared to the mattercontrol quality and filament settings.
However, when I run a print on Repetier-host it is printing WAY too close to the bed all of a sudden whereas with Mattercontrol it prints fine.

Anyone have any ideas or see any glaring issues here?

I am not entirely sure what my printable radius should be with a Max V2.

Rick