Welcome to the SeeMeCNC Community

Initial build

[img]http://i5.photobucket.com/albums/y159/Dougs90/3D%20Printer/Build/QzpcUHJvZ3JhbURhdGFcU0FNU1VOR1xTYW1zdW5nIExpbmtcY2FjaGVcMjAxNTAyMjZfMjM0NzEyLWFjOGZjNTFmMzY5YmNiMDdhZTcwYTUzNGJlNzdlMDY0LmpwZw.jpg[/img]

In action

http://vid5.photobucket.com/albums/y159 ... 221305.mp4

Still need to put together my build thread, one of these days!

Doug

I love the stripes! Great idea!

g.

That gives me an idea of putting a radioactive sticker somewhere on my V2 Nice build!

i also love the stripes. Maybe it will start a whole new Tiger series!

Thanks! I was shooting for an industrial look.

You need to add a rotating amber beacon on top and a klaxon that sounds right before it starts the print.

You could get an Arduino with an MP3 shield to play the klaxon sound that was heard when the shuttle bay doors were opening on ST:TNG. It could run the beacon too.


g.

No need for arduino, RAMBo have i2c, and there are i2c mp3 plates =) So, just it and firmware adaptation

Excellent idea!

g.

I had a biohazard sticker on a piece of test gear and didn't think about it when I sent the gear in for calibration. I received this phone call...