Welcome to the SeeMeCNC Community

Hey guys,

I built a RoStock Max V2 for my boss over an internship last summer. My printer back at home is different model. Anyway, I am back setting up a job for myself with my boss and working on his printer. Since I was here last you guys switched over to Matter Control. I've installed it and connected our printer, but I can't quite figure out how to load the presets and get our printer running. Is there some instructions for this somewhere?

Download the Matter Control Pre-Configured Profiles from the SeeMeCNC website and then import them into the settings page.

The instructions are on page 243 of the manual:

http://download.seemecnc.com/rostockmax ... dition.pdf

Thanks, my manual is pre Matter Control. I'll check out the new one.