Updating my upgraded H-1 with H-1.1 parts
Posted: Mon Aug 13, 2012 4:44 pm
So far no issues other than pulling my heated bed apart and mangling the table a bit.
I've got everything back together and it all slides much smoother.
I'll be spending the next few days replacing the perm-a-temp wiring I had with something a lot more permanent so I can focus on printing and not adjusting.
My printer has been down too long, but that just because I've been traveling too much during the week and taking care of the farm on the weekends.
Pics to follow - it's been too long since I've participated here. I can't wait to try printing with the smaller acorn nozzles.
I've got everything back together and it all slides much smoother.
I'll be spending the next few days replacing the perm-a-temp wiring I had with something a lot more permanent so I can focus on printing and not adjusting.
My printer has been down too long, but that just because I've been traveling too much during the week and taking care of the farm on the weekends.
Pics to follow - it's been too long since I've participated here. I can't wait to try printing with the smaller acorn nozzles.