Page 1 of 1
Custom building and scaling.
Posted: Fri Mar 27, 2015 9:40 pm
by lehthanis
As I mentioned in another thread I'm thinking about building my own rostock based printer but id like to scale it up. Especially in the diameter department. What kind of things do I need to consider when scaling the design up? Where would I get a larger heated bed that's round? Anything else I should consider before scaling up?
Re: Custom building and scaling.
Posted: Sat Mar 28, 2015 8:30 am
by teoman
Tjere is a site that lets you calculate the arm lengths etc and the precision you will obtain.
There are a few big printers on this site. Contacting the creators would be a good start.
Re: Custom building and scaling.
Posted: Sun Apr 12, 2015 9:19 pm
by TFMike
teoman wrote:Tjere is a site that lets you calculate the arm lengths etc and the precision you will obtain.
There are a few big printers on this site. Contacting the creators would be a good start.
what site is that?