Page 1 of 1
H1.1 Assembly Manual
Posted: Thu Aug 16, 2012 11:30 am
by Paul Kelley
I only see 3 assembly steps for the H1.1. Would the H1 assembly manual be valid for the rest?
Re: H1.1 Assembly Manual
Posted: Thu Aug 16, 2012 11:30 am
by johnoly99
We will be finishing up the official assembly manual shortly
Re: H1.1 Assembly Manual
Posted: Wed Aug 22, 2012 8:22 pm
by niner_zero
Any update on this?
Re: H1.1 Assembly Manual
Posted: Tue Aug 28, 2012 1:27 am
by codenomad
*bump*
Re: H1.1 Assembly Manual
Posted: Tue Aug 28, 2012 10:40 am
by johnoly99
The Official manual writer guru has been working on finishing it up. If there's anything specific you would like to see included in the manual, ask for it in the post here. Thanks
Re: H1.1 Assembly Manual
Posted: Sat Oct 13, 2012 11:01 am
by dmpalmer
I was totally baffled by Step 5, putting together the bearings. Nothing looked the same.
Fortunately, the pictures in
jcugnoni's post (#25) in this thread and
the picture of what's included in the upgrade kit showed me how to ignore that step.
(I still don't know what the black plates: top middle of that picture, are for, but I assume I'll figure it out or find the appropriate post once I run into that roadblock.) Edit: They are timing-belt clamps. Fold them in half to lock on to the belt cogs.
Edit:
Also, I didn't know that the bar clamps now go on top of the Z carriages until I saw the
video. If you put the clamps on the bottom there is no place to drill holes for the two screws on each timing-belt clamp.