Welcome to the SeeMeCNC Community

Posted: **Wed Apr 29, 2015 10:55 am**

We built the rostock MAX v2 and every print we make it makes a groove at an angle in the part. We were wondering if it could possibly be a calibration issue?

Posted: **Wed Apr 29, 2015 1:17 pm**

I would check that your u-joints move freely and don't have a snag anywhere in their travel. A little lubrication wouldn't be a bad idea either.

Posted: **Sun May 10, 2015 11:59 pm**

Did you fix it?

Welcome to the SeeMeCNC Community

Printing a groove in all the objects

Printing a groove in all the objects

Re: Printing a groove in all the objects

Re: Printing a groove in all the objects