Rostock V1 temperature setting of heat rod
Posted: Wed May 06, 2015 10:18 pm
Hi guys,
We are stuck on the test cube. We are using ABS right now and our settings in the configure of slicer is 235(heat rod) and 80(heat bed)
But! Everytime we start printing, the default temperature of the rod will decrease to 200 and start to print. Then, it will increase temperature while printing.
Can anyone help?
Besides, ABS cannot adhere to the glass.......
We are stuck on the test cube. We are using ABS right now and our settings in the configure of slicer is 235(heat rod) and 80(heat bed)
But! Everytime we start printing, the default temperature of the rod will decrease to 200 and start to print. Then, it will increase temperature while printing.
Can anyone help?
Besides, ABS cannot adhere to the glass.......