Welcome to the SeeMeCNC Community

Well priorities have changed since buying this printer. Purchased in December of last year. It is almost ready to have the wiring connected to the Rambo board(have not had time to work on it stupid work). I would finish it but I just received my radon testing results for my home back and they are very high. My children's health is more of a priority than 3d printing. Only selling so I can put a radon system in my house. It will ship whole minus spool mount on top. It will be double boxed and packed very well. Asking 900 shipped for it. Includes everything that you would receive from seemecnc plus a roll of abs material and spare hotend. It has an upgraded 600w power supply and the astrosyn stepper dampers installed as well. Any questions feel free to ask.

Pictures available upon request as for some reason it won't let me attach them to this post.

Where do you live?

I am located in Wisconsin.

I have finished wiring and started with calibration of the printer(still need z height and endstops adjusted). Still need to sell for the radon system.

If the forum is silently rejecting your pictures, it might be because they're over a filesize limit. I think it's 5mb per picture? Not sure, but try scaling them down.

Good luck with your sale, and stay safe!

You can do the endstops in eeprom.

I got curious an did a bit of reading...

Radon cleaning systems seem to be just air evacuation systems.

If you are the tinkerer type and have means of getting your house checked again, why not 3d print it?

SOLD