Page 1 of 1
Can the stock wiring handle 3 stock layer fans?
Posted: Wed Jun 10, 2015 9:07 pm
by EL Cuajinais
I am considering adding two additional stock layer fans for a total of three. Can the thin wires included in the build (I think they are 22 AWG) handle the current for three stock layer fans?
Thanks.
Re: Can the stock wiring handle 3 stock layer fans?
Posted: Wed Jun 10, 2015 9:19 pm
by bot
Yes. I have three fans all hooked up in parallel with a single quick disconnect to the stock wires. It's been fine for over 1,000 hours of printing.
Re: Can the stock wiring handle 3 stock layer fans?
Posted: Wed Jun 10, 2015 11:11 pm
by EL Cuajinais
Thanks!
Re: Can the stock wiring handle 3 stock layer fans?
Posted: Mon Jun 22, 2015 8:25 am
by lumpy_potato
bot wrote:Yes. I have three fans all hooked up in parallel with a single quick disconnect to the stock wires. It's been fine for over 1,000 hours of printing.
Did you use the SeeMeCNC blower or another model?
Re: Can the stock wiring handle 3 stock layer fans?
Posted: Mon Jun 22, 2015 2:23 pm
by bot
SeeMeCNC blower.
Re: Can the stock wiring handle 3 stock layer fans?
Posted: Mon Jun 22, 2015 6:28 pm
by bvandiepenbos
3 fans is no problem with stock wiring.