Page 1 of 1
Y axis is the only one to go up
Posted: Fri Jun 19, 2015 10:00 am
by dsl158
https://www.youtube.com/watch?v=nPANpxtPIz4
When ajusting the z height the Y Axis is the only one to go up but they all go down
*edit youtube link is now fixed
Re: Y axis is the only one to go up
Posted: Fri Jun 19, 2015 11:52 am
by Mac The Knife
Fixed
Re: Y axis is the only one to go up
Posted: Fri Jun 19, 2015 1:16 pm
by dsl158
Mac The Knife wrote:Spam Much? That link is NSFW.
oh god im so sorry I had the wrong thing on my clipboard
Re: Y axis is the only one to go up
Posted: Fri Jun 19, 2015 3:05 pm
by Dale Eason
Maybe the top home switchs on those towers do not work and are always set on. Check them as described in the manual.
Dale