Page 1 of 1
Hot End stepper motor not feeding plastic
Posted: Fri Jul 31, 2015 3:21 pm
by Potatohead908
I am still in the process of setting up my MAX V2. Everything has worked as it should to this point in the instructions up to this point. I can move the stepper by hand with the power on so I'm thinking it doesn't have power. This could be a wiring issue or a fuse issue. I will look into the wiring tonight when I get home. Is there any other things I should look at? Again everything else has worked up to this point in the instructions. I have calibrated the axis and am almost ready to start printing.
Re: Hot End stepper motor not feeding plastic
Posted: Sat Aug 01, 2015 2:39 am
by Potatohead908
Simple fix. I skipped two sockets instead of one when I connected the stepper to the board. Ooops!
Re: Hot End stepper motor not feeding plastic
Posted: Sat Aug 01, 2015 10:22 am
by Eaglezsoar
Potatohead908 wrote:Simple fix. I skipped two sockets instead of one when I connected the stepper to the board. Ooops!
Hey, at least you got it fixed!
Re: Hot End stepper motor not feeding plastic
Posted: Sun Aug 02, 2015 2:53 pm
by Potatohead908
Eaglezsoar wrote:Potatohead908 wrote:Simple fix. I skipped two sockets instead of one when I connected the stepper to the board. Ooops!
Hey, at least you got it fixed!
Yes!! It is now officially ALIVE and COMPLETE!! The first thing my oldest son asked me to print was too big!! Go figure!