Page 1 of 1
Square Lamp #1
Posted: Sat Aug 15, 2015 7:52 pm
by cameron98199
I recently made a lamp. It is made of two printed structures; a base and a translucent shade. The base is printed in silver colored PLA, measuring 6"x6"x12" - print time 29 hrs. The shade is printed is 'soulful blue' approx. 6"x6"x6", 0.05" thick wall - print time 10 hrs. Both parts are printed as one piece with no supports used. Parts were printed on a Rostock MAX V1.
Re: Square Lamp #1
Posted: Sat Aug 15, 2015 10:15 pm
by stonewater
how about some close ups of the intersections?
Re: Square Lamp #1
Posted: Sat Aug 15, 2015 10:25 pm
by Jimustanguitar
KONA!
Re: Square Lamp #1
Posted: Sun Aug 16, 2015 7:40 am
by Holy1
Good job, looks great!
Re: Square Lamp #1
Posted: Sun Aug 16, 2015 2:30 pm
by Eaglezsoar
Nicely done!!
Re: Square Lamp #1
Posted: Sun Aug 16, 2015 8:17 pm
by Agisis
That is a really nice job. Well done!
Re: Square Lamp #1
Posted: Thu Aug 20, 2015 8:10 pm
by cameron98199
stonewater wrote:how about some close ups of the intersections?
As requested, here are some additional images.
Thanks,