Welcome to the SeeMeCNC Community

Hello.

I was hopping to get a little help. I have tried everything I can think of to get my gShield v5b to work, no matter what I do I can not get it to respond to anything.

I have tried mhackney hex file, I tried SeeMeCNC's hex file. I have tried compiling the code from grlb github and nothing.

The arduino uno seems to connect with no problems.

thanks for any help.

grandleo75 has posted this on Thursday, August 27 and so far no replies.
Could someone with a droplit help out?

I have made a little progress. I manage to get Grbl's firmware from github to work. I had to move the files from the grbl folder to the main liberary folder. Then I was able to compile it on to the Arduino Uno.

However, I can not get the endstop to work. I have it connected to the pins that SeeMeCNC instructions told me to, but I am guessing because I used different firmware, it is not aware of the endstops pin location