Motor turning calibration
Posted: Sun Sep 30, 2012 10:39 am
Anyone know of any good links for calibrating the H1-1? I went to that one
link that shows what the devs use for their turning settings however when I
use those my prints come out about x10 normal size. To fix this problem do I
just reduce the motor turning to 1/10th of the current settings? Also my
motors are 1.7A and it would seem the motors that normal come with the kit
are around 3 amps, if that makes a difference in any kind of setting.
link that shows what the devs use for their turning settings however when I
use those my prints come out about x10 normal size. To fix this problem do I
just reduce the motor turning to 1/10th of the current settings? Also my
motors are 1.7A and it would seem the motors that normal come with the kit
are around 3 amps, if that makes a difference in any kind of setting.