Rostock Max V2 lower than 100microns?

Martin_Kierstein · Post by **Martin_Kierstein** » Wed Oct 21, 2015 9:28 am

Hi Everybody

n00b question from a beginner.

I read somewhere that it might be possible, by upgrading the stepper motors on the RMv2, to get it down to 50 microns.

Does anyone know if this is possible?

Thanks in advance

Martin

Post by **geneb** » Wed Oct 21, 2015 9:38 am

You can do it with a stock machine (I've done it with a v1), but it's very, very, slow.

g.

Martin_Kierstein · Post by **Martin_Kierstein** » Wed Oct 21, 2015 9:41 am

Hi Gene

Thanks!

I use MatterControl.
So I can just set the layer height to 0.05 then?
I thought the minimum stock setting was 0.1 ...

/Martin

teoman · Post by **teoman** » Wed Oct 21, 2015 9:42 am

Some have printed with 50 micron layer heights.

Welcome to the SeeMeCNC Community

Rostock Max V2 lower than 100microns?

Rostock Max V2 lower than 100microns?

Re: Rostock Max V2 lower than 100microns?

Re: Rostock Max V2 lower than 100microns?

Re: Rostock Max V2 lower than 100microns?