Page 1 of 1
Duet v0.8.5 annotated board
Posted: Wed Oct 21, 2015 8:33 pm
by mhackney
Here is an annotated photo of the Duet v0.8.5. The folks at Think3DPrint3D did the original and I annotated the stepper and endstops, power and PanelDue connector.
I'm waiting to hear back from t3p3 on the probe header.
Re: Duet v0.8.5 annotated board
Posted: Thu Oct 22, 2015 7:51 pm
by Eaglezsoar
mhackney wrote:Here is an annotated photo of the Duet v0.8.5. The folks at Think3DPrint3D did the original and I annotated the stepper and endstops, power and PanelDue connector.
Duet_0.8.5_Wiring.jpeg
I'm waiting to hear back from t3p3 on the probe header.
Great post!
Re: Duet v0.8.5 annotated board
Posted: Fri Oct 23, 2015 11:43 am
by 0110-m-p
Thanks for the extra annotations. I'm ordering one today for a new delta that I've been designing. This board looks very promising after reading some of the posts on here and over on the reprap forums.