Is this only marlin/ RAMPS?
Posted: Sun Oct 21, 2012 7:36 pm
just wondering if this can only be controlled by a modified marlin firmware on RAMPS? I cant use a 4 axis board with it right? Thinking of atleast printing out a smaller one
tom, as of right now, I don't think Mach3 can run this (cough, yet, cough), but i hear birds chirping that it can/will control delta bots soon....
So, yes, right now you would have to use a reprap electronics setup such as RAMPS, RAMBo, printrboard etc...