I am at my instillation stage for software. Everything was working fine until I installed MatterControl. I did the M119 and checked the stops. After I put in the new coordinates to move it down a couple CM. It just went blank. My rostock is not connecting to any of the computers. Matter Control after i send it home just says... wait and after i disconnect and connect. It wont connect anymore. I even used Repetier Host also and it will not connect. Front panel says it is Rostock MAX OK. I looked at Device Manager and it says it working fine. I am lost right now and can't continue. Need some help. Don't know what to do. Now it just says "killed"
[img]http://i800.photobucket.com/albums/yy284/cadilovr/IMG_5692.jpg[/img]
[img]http://i800.photobucket.com/albums/yy284/cadilovr/IMG_5691.jpg[/img]
Rostock Max V2 not connecting
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Rostock Max V2 not connecting
What version of Repetier Firmware, what version of MatterControl.
What type of computer Windows or Mac.
What type of computer Windows or Mac.
Re: Rostock Max V2 not connecting
Newest Versions of both. MatterControl 1.4. Reperier Host 1.6.0. Windows 8 on one and Windows 7 on another. Happens to both computers. Just got the Rostock a week ago. When I turn it off and on again on the printer it goes back to being Rostock "OK".
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Rostock Max V2 not connecting
Ensure the baud rates in device manager and matter control match.
There have been issues with Matter Control but I do not use it so we need another member to advise.
Sometimes a new USB cable can help but rarely.
Other users who run Matter Control please help with this thread.
There have been issues with Matter Control but I do not use it so we need another member to advise.
Sometimes a new USB cable can help but rarely.
Other users who run Matter Control please help with this thread.