Welcome to the SeeMeCNC Community

Posted: **Wed Dec 16, 2015 10:40 am**

I see that some of the software topic sections have had no use since 2013 perhaps those topics could be reset for OnShape?
http://3dprintingindustry.com/2015/12/1 ... hape-apps/
Fusion360 might also make more sense than then little used ones

Posted: **Wed Dec 16, 2015 3:12 pm**

I'm not sure why we need so many sub-forums anyway. I always just "search for new posts" or "active posts" or the like... The topics should be more general, not more specific.

Welcome to the SeeMeCNC Community

Should OnShape and Fusion360 have their own section here

Should OnShape and Fusion360 have their own section here

Re: Should OnShape and Fusion360 have their own section here