Page 1 of 1
Rostock Max V2 + Enclosure, Extras $1000
Posted: Sat Dec 19, 2015 10:52 am
by dkaustin
Rostock Max V2 with polycarbonate enclosure, two E3Dv6 hotends with extra 0.4mm nozzles, FSR's, Astrosyn-type dampers, new boro build plate, copper heat spreader, filament spool holders with turntable and dessicant cartridges, floor stand. Printer is located in western suburbs of Chicago, asking $1000. Local pickup, cash only, please.
Re: Rostock Max V2 + Enclosure, Extras $1000
Posted: Sat Dec 19, 2015 6:06 pm
by teoman
Nice unit you have built.
People are always suspicious when buying second hand stuff especially delicate and functionnal stuff.
Why not poat pictures of some calibration prints and cool stuff you have printed to erase doubts that people may have regarding the purchase of someones failed printer build.
Re: Rostock Max V2 + Enclosure, Extras $1000
Posted: Sat Dec 19, 2015 10:40 pm
by plasma
If you don't mind me asking? What type of corner molding did you use for the enclosure.
Thanks
Re: Rostock Max V2 + Enclosure, Extras $1000
Posted: Sun Dec 20, 2015 8:29 am
by dkaustin
The corner molding is a Slip-On Plastic Piano Hinge from McMaster-Carr, part number 1793A61.
Re: Rostock Max V2 + Enclosure, Extras $1000
Posted: Sun Dec 20, 2015 11:44 am
by plasma
Thanks
dkaustin wrote:The corner molding is a Slip-On Plastic Piano Hinge from McMaster-Carr, part number 1793A61.
Re: Rostock Max V2 + Enclosure, Extras $1000
Posted: Tue Aug 23, 2016 9:28 pm
by Nazulle
What did you use for the base and the top of the enclosure to keep the panels in place?