How do I change E motor microstepping from 1/16 to 1/8?
Posted: Thu Jan 07, 2016 9:40 pm
I've peeked into the firmware and it's clearly quite easy to change microstepping for XYZ axes... but that's not what I want to do.
I am going to attempt to mount one of Mutley's custom "Flexstruders" with a flexible drive shaft to the effector platform. This will enable "Direct drive" printing on the Rostock. Pretty cool right?
Only problem is that his mod requires 1/8th microstepping on the E axis... and as far as I can tell there is no way to do that in firmware. Anyone know how to do this?
Thanks.
I am going to attempt to mount one of Mutley's custom "Flexstruders" with a flexible drive shaft to the effector platform. This will enable "Direct drive" printing on the Rostock. Pretty cool right?
Only problem is that his mod requires 1/8th microstepping on the E axis... and as far as I can tell there is no way to do that in firmware. Anyone know how to do this?
Thanks.