Welcome to the SeeMeCNC Community

Hi all,

i'm new owner of the Rostock Max V2. I already have the Replicator 2 and the Prusa I3 Hephestos modified to steel.

Here my thingverse page: http://www.thingiverse.com/RenatoT/about

Still i'm fixing some little assembly problems because my Rostock Max was mounted by 2 friends and something is not prefectly aligned (i think).

Here a video that show my current problem.. even i just measured the 3 bars.. and the right is highest of about 1 cm.
https://www.youtube.com/watch?v=m6iyXF82-uk.

best regards all
Renato

Hello Renato and welcome to the forum!
I would like to thank you for buying the Rostock Max V2 from SeeMeCNC.
I am sorry that you are having problems and after viewing your video I am not sure what is causing the problem.
Could you do me a favor a post your video and questions to the Troubleshooting sub-forum, there it will get more exposure.
If this does not get figured out after posting in the troubleshooting area then find my avatar or user name and send me a private message,
I want to make sure this is resolved.
Best of luck!