Welcome to the SeeMeCNC Community

Does anyone know what the difference is between the stock MatterControl and the SeeMeCNC flavor of the app?

Thanks,
Nathan

The logo.

g.

Haha, Only reason I am asking is that even with the 1.5 alpha build I still am unable to use the auto bed leveling without artificially increasing the max z height in the eeprom. It always say that it cannot go lower when I have the Z height set properly. I have my hotend mounted below the effector platform so I thought that maybe the SeeMeCNC version of matter control was enforcing some max z height based on if the hotend was mounted in the stock configuration.

Don't use the auto-bed leveling. It will only compensate for a tilted build platform and won't cure a mis-calibrated delta.

g.

@Gene
I have a perfectly calibrated Orion, but there is quite a variance in my height from the effector and the build plate.
(See http://forum.seemecnc.com/viewtopic.php ... 95&p=85546)

I rely on MatterControl to accommodate this variance.