Welcome to the SeeMeCNC Community

First non-fan shroud printing project I tried was this tool/glue stick organizer for BD: http://www.thingiverse.com/thing:1140304

It took about 5 hours to run out of 1.7mm PLA, came out really nice. I then painted it black & green to match BD's color scheme... Looks factory-fresh!

Looks nice! Good job and thanks for the picture!

Nice, I printed one of these but it doesn't fit the australian 'uhu' gluesticks

I should have measured before I printed!

Was that a sly "Everything is bigger in Australia!" joke?

g.

geneb wrote:Was that a sly "Everything is bigger in Australia!" joke?

Not bigger; uʍop-ǝpısdn.