Page 1 of 1
Layer cooling fan shroud for E3D mounted under effector plat
Posted: Wed Mar 02, 2016 1:33 pm
by REV
Hi all-
I've printed some of @626Pilot's 'Lucky Number 7' fan shrouds:
http://www.thingiverse.com/thing:487768 but they seem to be made for a different, most likely older, effector plate. Provided you have the same setup as I do, what do you do for your layer cooling needs?
[img]
[/img]
Re: Layer cooling fan shroud for E3D mounted under effector
Posted: Thu Mar 03, 2016 6:56 pm
by barry99705
Re: Layer cooling fan shroud for E3D mounted under effector
Posted: Fri Mar 04, 2016 7:31 am
by barry99705
Okay, I'm a dumbass. Should have looked in the parts bins before printing! Thought I still had that fan, guess not... So, I printed up this instead!
http://www.thingiverse.com/thing:1284511
It will fit the fan we already have. Installing tonight if I have time. Who am I kidding, it's friday, I'll have time!
Re: Layer cooling fan shroud for E3D mounted under effector
Posted: Fri Mar 04, 2016 10:14 am
by Eaglezsoar
barry99705 wrote:Okay, I'm a dumbass. Should have looked in the parts bins before printing! Thought I still had that fan, guess not... So, I printed up this instead!
http://www.thingiverse.com/thing:1284511
It will fit the fan we already have. Installing tonight if I have time. Who am I kidding, it's friday, I'll have time!
Thanks for mentioning that, I didn't know it was there.