Welcome to the SeeMeCNC Community

Should I feel bad for laughing at this?

Which one is you Eaglezsoar?

Looks like fun except for the guy on the far right who fell the furthest. Hope all were OK.

Note to self. Stand on the upper side unless your friends are of the type to....... all jump off at once.

Thanks for posting!!

You might need this:

http://www.thingiverse.com/thing:2673

Jimustanguitar wrote:You might need this:

http://www.thingiverse.com/thing:2673

I am not in the picture but I thought it was funny!

Jimustanguitar wrote:You might need this:

http://www.thingiverse.com/thing:2673

I'm sure a spheroid made out of a couple dozen flat facets would be good to use in a load-bearing ball joint inside someone's body. What could go wrong?

626Pilot wrote:

Jimustanguitar wrote:You might need this:

http://www.thingiverse.com/thing:2673

I'm sure a spheroid made out of a couple dozen flat facets would be good to use in a load-bearing ball joint inside someone's body. What could go wrong?

Depends on if you're trying to print the ball cup in ninjaflex with the stock hot end or not...