Welcome to the SeeMeCNC Community

Can someone tell me which ribbon cable goes to whichconnector on the new rambo adapter? Thanks. Bill

If you look at the pin out from the lcd wiring instructions. You can determine which is which by reading the pins with a multimeter

but I've done this already. The "A connector" (left most wire on lcd panel) is the top header on the adapter board . "B connector" is the bottom header. I have photos in my build log.

I'm also waiting for an email from john at seemecnc just to verify. I'm correct.

Thank you so much, I talked Steve today and he even didn't know.....