Build question: pulley fit?
Posted: Thu Feb 07, 2013 6:15 pm
Hi,
This is my first build (H1.1) and I am right now working on the rear base sub assembly. I am trying to fit the pulley onto the stepper motor as shown here: http://seemecnc.org/download/H1-1/H1_1% ... sembly.PDF but I'm not sure how far down to press it in to place. Should I basically push it all the way on? I'm hesitant to push it too far on, since taking it off of the shaft seems nearly impossible given how tight the fit is.
Here's a picture of the area I am talking about: [img]https://lh3.googleusercontent.com/-hwZc ... G_8853.JPG[/img]
This is my first build (H1.1) and I am right now working on the rear base sub assembly. I am trying to fit the pulley onto the stepper motor as shown here: http://seemecnc.org/download/H1-1/H1_1% ... sembly.PDF but I'm not sure how far down to press it in to place. Should I basically push it all the way on? I'm hesitant to push it too far on, since taking it off of the shaft seems nearly impossible given how tight the fit is.
Here's a picture of the area I am talking about: [img]https://lh3.googleusercontent.com/-hwZc ... G_8853.JPG[/img]