Upgraded 2014's Repeteir firmware to most recent... temp sensor problems now
Posted: Tue Jan 10, 2017 12:07 am
I use a mostly stock Rostock Max V2, except I use a Budaschnozzle with a Honeywell 100K axial thermistor, carbon arms, and a flying extruder. It's super simple to change most of the hardware parameters, and I could migrate really easily to a point where the printer basically works... except...
It has the wrong thermistor settings. I'm positive. The print quality of actual filament is really bad.
I need to know how to point the config.h file to the proper thermistor table, which should be type 67 in extruder.cpp? Maybe? I exchanged the number 97 for 67 at line 90 in the code, and it didn't work at all. When I do that, the thermistors both read DEF DEF and the printer doesn't work at all!
Any assistance appreciated!
It has the wrong thermistor settings. I'm positive. The print quality of actual filament is really bad.
I need to know how to point the config.h file to the proper thermistor table, which should be type 67 in extruder.cpp? Maybe? I exchanged the number 97 for 67 at line 90 in the code, and it didn't work at all. When I do that, the thermistors both read DEF DEF and the printer doesn't work at all!
Any assistance appreciated!