Welcome to the SeeMeCNC Community

I don't know if you have seen these but Cambo3D has a very cool two piece J-head mount for sale that accepts the brass fitting from the stock Rostock Bowden Tube. These are designed to fit on the stock Rostock effector base.

In this photo, I have a hotends.com j-head that I have inserted into the bottom piece of the mount. The other mount with Bowden tube brass fitting goes over the top of the head keeps the J-head securely in place.

Also in the photo is a mount for the E3D head.

To install these, you can use the stock 1" standoff (metal tube); however, i think you'll find the distance between your head and the effector base a little tight. You might consider 3/4" standoffs. (Don't forget to recalibrate!!!)

He's selling them made to order here:

http://www.ebay.com/itm/Aluminum-J-head ... 1143632013

I was happy with Cambo3D's availability to answer questions, his answers and the speed at which he delivered the mounts.

(I thought I would post before I mounted and then update this post a bit later with the full assembly.)

hey that mount looks good..

but just for anyone that wants one, this is same mount (well almost the same) listed on thingiverse that is 3d printable.

I just made this version in aluminum and custom fit for the ed3, rostock, and also other jheads.

Care to whip one up for 2 j-heads?

foshon wrote:Care to whip one up for 2 j-heads?

pm me, tell me what your looking for.