Welcome to the SeeMeCNC Community

Posted: **Mon Feb 03, 2014 3:20 pm**

hi all

sorry i wasn't been here alot lately , it's exams time and i'm study alot but from time to time, at the night i give the printer to print...
few min ago the printer got dead in middle of printing , as i look at the board i saw 3 fuses, 1 big ( like a car fuse) and 2 very small ones, when i made a jumper on one of them the printer got her life again ,
so now i need new micro fuse that i don't know where to buy, anyone know and can help me ?

the picture here show witch fuse burn to death
Thanks

Posted: **Mon Feb 03, 2014 3:32 pm**

The original 5A fuse is
LittleFuse 0451005.NRL

The 10A version is
LittleFuse 0451010.NRL

Available from Mouser.com or Digikey.com

You can use the 10 amp fuses.

Buy some spares.

Posted: **Mon Feb 03, 2014 3:42 pm**

Thanks Eagle , they sold it only in 5000 pieces, all i need is 10....

Posted: **Mon Feb 03, 2014 3:52 pm**

Orenfor wrote:Thanks Eagle , they sold it only in 5000 pieces, all i need is 10....

I just went to mouser.com and searched for 0451010.NRL They sell them quantity one at $1.52 and qty 10 at $1.22 ea.

Posted: **Mon Feb 03, 2014 6:12 pm**

before you replace it with a 10Amp be sure to find out what caused it to blow

Posted: **Tue Feb 04, 2014 1:29 am**

well. I didn't find any on the site. But I did find them on eBay so I buy 10 . About the reason i know why it's happan, i try to be smart . I put mono audio connector to the hot end and it's start to disconnect, got heat and make the fuse burn....

Welcome to the SeeMeCNC Community

I think i blow one of the fuses

I think i blow one of the fuses

Re: I think i blow one of the fuses

Re: I think i blow one of the fuses

Re: I think i blow one of the fuses

Re: I think i blow one of the fuses

Re: I think i blow one of the fuses