Page 1 of 1
mach 3 where to start!
Posted: Wed Jun 13, 2012 10:10 pm
by tom10122
not familar withit at all, tried fooling around with it and cant get anything to happen. only plugged in two motors and all ports except the y port makes the motors whine. Iguess my first question is how to get them to move?
Re: mach 3 where to start!
Posted: Thu Jun 14, 2012 3:50 pm
by jbinion
Re: mach 3 where to start!
Posted: Thu Jun 14, 2012 7:29 pm
by tom10122
thanks, finally got it set up with some help but, when i use hot keys and even some other times with cycle start, the steppers,"skip" they try to move but dont,they start to move then skip, if i want the y axis to move, i gotta repeatedly press the button for a while to get it to get to where i want it , any ideas?
Re: mach 3 where to start!
Posted: Thu Jun 14, 2012 7:33 pm
by tom10122
nvrmind, got it , they were moving too fast
