Page 1 of 1
Orion Settings for Cura
Posted: Mon Jan 26, 2015 11:01 am
by D-Ring
Anyone have configuration for setting up the Orion printer in Cura. Looking for the machine profile. I can do the print profiles that I have been using with MatterControl and transfer them over, just looking to play with the cura software to compare
Re: Orion Settings for Cura
Posted: Mon Jan 26, 2015 11:26 am
by Jimustanguitar
http://slicershare.com/files/2406-2/
Here's what I use on my Rostock with a .4mm nozzle. There are a few changes between that and an Orion, but not many besides the actual build area.
Re: Orion Settings for Cura
Posted: Mon Oct 26, 2015 10:50 am
by Renha
404
Re: Orion Settings for Cura
Posted: Mon Oct 26, 2015 12:37 pm
by Jimustanguitar
Renha wrote:404
Their website is acting strange. Not that it was awesome to begin with
Does the direct link to the file work?
http://slicershare.com/wp-content/uploa ... s/2406.ini
If not, I posted the same .ini file on the MakerHive forum:
http://makerhive.proboards.com/thread/8 ... -materials