Page 1 of 1
Guess What this will be used for
Posted: Sat Feb 07, 2015 7:47 am
by teoman
A hint: 99% of people here might have an application for it.
PS: it is not a full component. It is a model that will be fused in to other stuff.
Re: Guess What this will be used for
Posted: Sat Feb 07, 2015 11:13 pm
by Jimustanguitar
Looks like a self tensioning linear bearing for an extrusion...
Whatcha buildin'?
Re: Guess What this will be used for
Posted: Sat Feb 07, 2015 11:34 pm
by teoman
Yep.
It attaches to the towers of the rostock towers.
I am implementing something like foshon did. Nozzle purger/primer before printing.
I design the other part holding the servo, get the fusion angle correct and the fuse it.
Re: Guess What this will be used for
Posted: Sun Feb 08, 2015 5:49 pm
by Eaglezsoar
teoman wrote:Yep.
It attaches to the towers of the rostock towers.
I am implementing something like foshon did. Nozzle purger/primer before printing.
I design the other part holding the servo, get the fusion angle correct and the fuse it.
Be sure to show pictures of the finished product, that looks interesting!
Re: Guess What this will be used for
Posted: Mon Feb 09, 2015 9:02 am
by teoman
Will do,
I already have 2 parts printed. Will need time to assemble them and then take pictures.